ISO-SAFETY DESIGN OF FLAT SLABS IN ACCORDANCE WITH EUROCODE 2

Simple item page
dc.contributor.authorALIYU, Ibrahim
dc.date.accessioned2016-06-11T12:56:35Z
dc.date.available2016-06-11T12:56:35Z
dc.date.issued2015-02
dc.descriptionA THESIS SUBMITTED TO THE SCHOOL OF POSTGRADUATE STUDIES, AHMADU BELLO UNIVERSITY ZARIA-NIGERIA, IN PARTIAL FULFILLMENT OF THE REQUIREMENTS FOR THE AWARD MASTER OF SCIENCE DEGREE IN CIVIL ENGINEERING (M.Sc. (CIVIL)). DEPARTMENT OF CIVIL ENGINEERING FACULTY OF ENGINEERING, AHMADU BELLO UNIVERSITY ZARIA-NIGERIAen_US
dc.description.abstractThis research work focuses on the development of Iso-safety design charts for flexural design of flat slabs at predefined reliability levels in accordance with Eurocode 2 (2004) design criteria. Constitutive models for reinforcing steel and concrete were selected in accordance with the Eurocode 2 design requirements and subsequently the flexural limit state function was derived. Charts were developed for the flexural design of rectangular reinforced concrete sections with respect to the position of neutral axis () for each concrete grade (fck) and steel grade (fyk). Uncertainties in loading and geometrical properties were obtained and a program was developed taken into consideration EC2 design requirements, a safety index β value of 1.81 was achieved for various points on each of the generated curve using First Order Reliability Method (FORM). Reliability-based design charts called Iso-safety charts were produced to target safety indices; βT of 3.3, 3.8 and 4.3 as the minimum recommended for the three failure consequence classes by Eurocode 0 (2002). This recommendation shows that Eurocode 2 design of flat slabs considering flexural failure with safety index value of 1.81 provides designs that are below the recommended target safety indices. A flat slab was there after designed using the charts and was shown that for the same loading and geometrical considerations, the area of flexural reinforcement required increased by 40%, 55% and 75% over Eurocode 2 design for corresponding target safety indices of 3.3, 3.8 and 4.3 respectively. Sensitivity analysis of these provided reinforcements was carried out on other flat slab failure modes and was observed that at low reinforcement ratios punching shear safety is dependent majorly on the effective depths rather than the flexural reinforcementen_US
dc.identifier.urihttp://hdl.handle.net/123456789/7976
dc.language.isoenen_US
dc.subjectISO-SAFETY DESIGN,en_US
dc.subjectFLAT SLABS,en_US
dc.subjectACCORDANCE,en_US
dc.subjectEUROCODE 2,en_US
dc.titleISO-SAFETY DESIGN OF FLAT SLABS IN ACCORDANCE WITH EUROCODE 2en_US
dc.typeThesisen_US
Files
Original bundle
Now showing 1 - 1 of 1
No Thumbnail Available
Name:
ISO-SAFETY DESIGN OF FLAT SLABS IN ACCORDANCE WITH EUROCODE 2.pdf
Size:
1.97 MB
Format:
Adobe Portable Document Format
Description:
Download
License bundle
Now showing 1 - 1 of 1
No Thumbnail Available
Name:
license.txt
Size:
1.58 KB
Format:
Item-specific license agreed upon to submission
Description:
Download
Collections
ENGINEERING