EFFECTS OF COPPER ADDITION AND SECTION THICKNESS ON SOME MECHANICAL PROPERTIES AND THE MORPHOLOGY OF GRAPHITE FLAKES IN GREY CAST IRON
EFFECTS OF COPPER ADDITION AND SECTION THICKNESS ON SOME MECHANICAL PROPERTIES AND THE MORPHOLOGY OF GRAPHITE FLAKES IN GREY CAST IRON
No Thumbnail Available
Date
2016-12
Authors
MUSA, ZAHRADDEEN
Journal Title
Journal ISSN
Volume Title
Publisher
Abstract
This study determined the effects of copper addition and section thickness on some mechanical properties and the morphology of graphite flakes in grey cast iron. It also characterised the microstructure of grey cast iron evolved in the investigation. This was of the view of ensuring that automotive industry designers are able to make informed choice between competing materials and grey cast iron, thus reducing the overall cost of the automobile. Four classes of grey cast iron containing 0.02, 0.55, 0.7 and 1.15% amount of copper were investigated. The section thicknesses of the produced grey cast iron were 10 mm, 25 mm and 75 mm respectively. The chemical composition, mechanical properties, graphite flake measurements and microstructural characterisation of each section of the casting were carried out with the aid of optical emission spectrometer, mechanical testing equipment and scanning electron microscope. The 0.7% Cu alloyed grey cast iron with section thickness of 10 mm produced the highest tensile strength of 150.28 N/mm2, hardness value of 47.5 HRC and the least impact strength of 76.96 kJ/m2. It was also discovered from microstructural characterisation that 10 mm section thickness has the shortest graphite flake length of 64.32 μm. However, the 1.15% Cu alloyed grey iron with 75 mm section thickness had the least tensile strength of 58.36 N/mm2, hardness value of 40.1 HRC and the highest impact strength of 107.13 kJ/m2. This also supported the longest graphite flake length of 105.68 μm. This is attributed to the fact that addition of copper up to 0.7% in grey cast iron enhanced the pearlite phase and promotes the formation of ferrite when increased to 1.15% by weight. The results of microstructural examination revealed that the morphology of the graphite flakes changes from fine and small flakes to coarse and long
Description
A DISSERTATION SUBMITTED TO THE SCHOOL OF POSTGRADUATE STUDIES,
AHMADU BELLO UNIVERSITY,
ZARIA
IN PARTIAL FULFILLMENT OF THE REQUIREMENTS
FOR THE AWARD OF A MASTER OF SCIENCE DEGREE IN METALLURGICAL AND MATERIALS ENGINEERING
Keywords
EFFECTS OF COPPER ADDITION, SECTION THICKNESS, SOME MECHANICAL PROPERTIES, MORPHOLOGY OF GRAPHITE FLAKES, GREY CAST IRON